TPS1A automatically folding corridor seat, wall-mounted, white

WHITE WAITING ROOM SEAT, AUTOMATICALLY FOLDABLE TPS 1A

Wall-mounted waiting room chairs automatically folded - TPS1A Twist Plus by AllHall will work very well in any waiting room, hall, corridor, hospital , clinic, office, airport, bank and many other places.

Straponten has steel fittings painted with white powder varnish. Its seat is made of plywood, covered with white laminate with milled edges revealing the natural color of the wood. The seat does not have a frame in direct contact with the ground, which means it takes up little space and makes it easier to keep the ground underneath clean.

The maximum load capacity of the straponten is 200 kilograms. It is characterized by a modern design and light construction.

Waiting room seats meet Polish and European standards regarding flame retardancy and toxicity of combustion products. At the customer's request, we provide test reports issued by accredited laboratories. The product has a 2-year warranty.

✅ SEAT FEATURES:

• Manufacturer's code: TPS1A li>
• Manufacturer: ALLHALL
• Weight (kg):12 kg
• Load capacity: b> 200 kg
• Dimensions (height): 44 cm
• Dimensions (width): 41 cm
• Dimensions (depth): 42 cm
• Dimensions: (deep after folding): 12 cm

  * All dimensions are external dimensions, excluding hooks and handles.

• Seat color: white laminate
• Frame color : white

✅COLORS AVAILABLE IMMEDIATELY!

In other auctions you will find automatic seats available immediately in the following colors:

• Grey
• Graphite
• Oak gray
• Oak graphite

✅EASY INSTALLATION!

Mounting to the wall is very simple. The package includes a Phillips screwdriver and an allen key.

In addition, you will need a 13 mm wrench, a spirit level and an impact drill with a 10 mm Widia drill bit.

Before starting assembly, check the contents of the package and the number of elements . Prepare free space and necessary tools.

✅PREPARE FOR INSTALLATION!

1. Tilt the seat to a horizontal position.

2. Slide the backrest up and remove it from the supporting frame.

3. Mark the K holes on the wall for the expansion plugs as shown in the drawing.

4. Drill K holes with a 10 mm drill bit to a depth of 65 mm.

5. Unscrew the pins, insert the screws through the holes in the frame and tighten the pins.

6. Place the frame against the wall by inserting the pins into the holes in the wall.

7. Insert the backrest hooks into the holes in the frame and slide the backrest down until it stops.

READY!

✅ATTENTION!

The distance of the lower holes from the floor given in the drawing - 490 mm, corresponds to a typical height of 450 mm. For a different seat height, please make the appropriate correction.