Sticker

Pattern:NITRO 75-16 P

Color: SILVER

• 1 pc 7.5x1.5cm

Additional information

• Manufacturing technique : plotter cutting along the outline
• Background: stickers do not have any background, the background is the surface on which they will be stuck
• Material: self-adhesive foil
• Resistance to: sun, frost, rain
• Color: color changeable according to the color chart on auction. If no color is selected after purchase, we will send the color shown in the auction

The stickers are made of high-quality Avery or Oracal foil, cut with a precise plotter . The stickers are resistant to weather conditions such as sun, rain, frost. The stickers are professionally prepared for gluing, covered with transport foil enabling the transfer of inscriptions and their sticking. The stickers do not have any background, the background is the surface on which they will be stuck. The stickers can be covered with clear varnish, at the buyer's request we add free foil scraps to test the clear varnish.

Important information:

1.The stickers have a layer of strong glue. We are not responsible for damage caused by incorrect sticker application or improper surface preparation (see gluing instructions)

2.The stickers do not have any background. The sticker contains a colorless transfer foil, used only to stick the graphics. The transfer foil may be cut unevenly, but this does not indicate a defect in the product. After sticking, the transfer foil and paper can be thrown away, only the graphics remain (see gluing instructions)

GLUING INSTRUCTIONS

1.Clean and degrease the surface on which you will stick the stickers , denatured alcohol or spirit.

DO NOT USE SOLVENTS SUCH AS NITRO, ACETONE, WHITE PETROL.

2. Before removing the paper, press the transparent foil to the sticker (with a flat surface or with your fingernail)

3. Remove the paper by pulling it up so that the graphics remain on the transparent foil. Note: do not touch the stickers on the adhesive side.

4. Stick the sticker together with the transparent foil, starting from one side and press all sticker elements evenly through the transparent foil to remove air.

5.Wait a few minutes and slowly remove the transparent foil.

ATTENTION! Do not glue on fresh varnish.