12-36V 500W BRUSHLESS MOTOR CONTROLLER

▶️Control terminal for SET:

1. Motor speed control wiring methods: the available speed of the potentiometer system can also be connected to the MCU control, when the potentiometer control wiring, the middle pin of the potentiometer is connected to the VR speed port, the potentiometer connected to both ends of the 5V voltage and GND higher speed faster.

3. Pulse speed signal: high and low output. The IC cannot understand the information at the customer's request.

4. Hall Signal Inputs: The wiring diagram is shown, one corresponding to HA, HB, HC and on the motor, 5V power supply connected to the hall motor signals positive , negative GND power supply signal to the motor hall. Motor driver board 12-36V DC power input, VCC positive power supply, GND power supply is negative.

5. Electrical wiring methods: brushless DC motor for three lines, corresponding to MA / U, MB / V, MC / W

▶️Specification:

• 100% new high quality
• Operating voltage: DC 12V-36V
• GND control terminal ground
• VR regulator end 0-5V (equivalent to 10 % motor speed -100%)
• ZF reversing control (connected to 5V or ground can load the motor rotation direction)
• M tachometer pulse output (depending on the number of motor poles corresponding to the number pulses per revolution of the output number)
• EL turns on the control terminal (connected to 5V without working with ground, then 5V, the motor ground stops)

  Control terminal 5V 5V.

  HALL for hall terminals:

  5V Hall positive power

  Ha Hall Signal

  Hb Hall Signal

  Hc Hall Signal

  GND Hall negative

▶️Package includes:

• 1 x 12-36V 500 W. Brushless motor controller

▶️Note:

1.If the line order is incorrect, it does not start properly, the current or other phenomena do not open, forced to use the drive board will burn!!!

2.If you use less than 60W without additional heat sink, please be sure to add more than 60W.

3. heatsink fins increase the performance without reducing the temperature is too high, they will shine for permanent damage!

4.The size of the heatsink may be due to the operation in poor environment (recommended cooling area greater than 200 square centimeters)!

5.When installing the heat sink, pay attention to the back of the module 6 MOS pipe insulation, no insulation, will stick to the drive disc permanently damaged! I suggest adding insulating foils on both sides of the insulating sheet and thermal paste!