Goldfitness barbell stands with protection and adjustable spacing GF1+GF2

Stability - Belaying - Adjustment= GF1+GF2

This is what distinguishes this model of Goldfitness barbell stands - now you can safely place the barbell on reinforced supports with additional regulation and protection.

Double-sidedness - Versatility = GF1+GF2

Additional supports - belays can be installed on one or the other side of the stands, depending on what exercises you want to perform

Technical data:

• Width at min - max. spacing 120-149cm
• Depth 85cm
• max height 162cm at the barbell location
• belay height 57-90cm
• Tube length for additional load 20 cm
• Powder-coated structure
• Product manufactured in Poland from high-quality steel
• The structural elements consist of 40x40mm and 35x35mm profiles

Possibility of adjusting to the height with up to 13 adjustment levels

• ✅ HEIGHT ADJUSTMENT allows you to adjust to your height, holes in the barbell supports are placed every 5 cm, which greatly facilitates training alone or with another person. The supports are adjustable in height from 94 to 160 cm (in 13 steps of 5 cm).
• ✅ ADJUSTMENT of support (belaying) up to 9 degrees every 5cm from 57 to 90cm
• ✅ ADJUSTMENT OF THE SPACE OF STANDS inside from 74 to 102cm and the total width of the stand spacing outside from 120 to 149cm

Securing stands and belaying

✅ Lock: once you have set the appropriate height of the support, you will lock it with a metal pin and additionally tighten the clamping knob, which will add stabilization to the barbell supports. The structure of the stands also includes another safety feature that can be used to put down the second bar or store it safely after training.

✅ The barbell grips have protection in the form of rubber covers, which are intended to dampen the barbell's deposition and increase its durability

✅ the belay supports also have rubber protection as well as protection with a metal pin and a pressure knob

Room for additional load and stability

✅ The structure of the stands includes tubes for additional load with a diameter of 21 mm and a length of 20 cm. After placing the load on the tubes, the stability of the stands is even greater, it is also a place to store additional plates.

Belaying - reinforcement

✅ The safety supports are mounted using two thick sheets fastened with 4 screws. Thanks to this solution, the manufacturer did not skimp on the material and this solution will increase stability and the stand will avoid the risk of possible weld cracking when putting the bar down.

✅ You can install the safety supports on either side of the stand, depending on the selected training, in a very simple way, by simply unscrewing two screws from the base.

Set completeness

✅ The set includes all construction elements and necessary assembly accessories, in addition two rubberized legs that allow you to set the stand to any width, it will also be useful for storing the stands. After dismantling the black connecting beam, you attach the legs to the ends of the profiles, then you get two separate stands. .